DIY Solar Panel Installation

 

 34

 

 

DIY Solar Panel Installation

 

 

 

If you’ve ever thought about the installation of your own solar panels to help save the environment and your hard earned money, then you’re doing good. Our guide gives you a quick overview of what is involved in the installation of solar panels. First things first, of the equipment. You’re going to need the solar panels themselves, brackets, rails, conduit, tape measure, laser vision sight, a stud finder, bolts and a drill. Check your solar panels instructions to see if you need any additions, as they may vary depending on which type you buy, before you start the installation.

Solar Panels Installation

Before you begin the installation, you need to complete an energy audit of your home so you know how many solar panels you need on the roof of your property, how many it will be able to take and how much you will save by using them. The Department of Energy will be able to give you advice on how to do it. You should also make sure that your installation of the solar panels are in position to capture the most sunlight throughout the day: do not site them in the shade or they will not work very good.

The installation brackets are the first thing you need to install and they need to be placed above the rafters of your house, because they secure the solar panels once ‘they are in place. Use a stud sensor, to locate the position of the rafters. Then use a laser sight to determine the precise location of your mounts. Then drill holes for the supports using a small pilot, which should help protect the rafters. Then attach the brackets to the roof using anchor bolts.

Your next mission is to use bolts and secure the rails to the mounts. Then it’s time to install the solar panels on individual tracks, carefully set in place before proceeding to the next stage. The final work is to attach a duct and run a cable from the power converter in your home and connect to the solar panels. Secure it properly so you do not have to worry about it moving or being damaged. Finally, check your new solar panels work properly. Overall, it is not too complicated to install your own solar panels, but you do need to be careful and take care, especially when working on the roof. You should get someone to help, to hold the ladder when using or tie it off securely, and to assist with lifting the solar panels and equipment up onto the roof.

You should also alert your local utility before installation as they can buy some of your solar power from you, and some of them require you to have one of their technician check out the installation. Also its good to get an expert to check your work before and after you, to ensure that the solar panels are secured and you meet all regulations.

Check out Amazon for DIY Solar Panels and Kits

 

1 Comment

  1. I just want to say I am very new to blogging and site-building and certainly savored this blog site. Most likely I’m likely to bookmark your blog post . You actually have superb article content. Thanks for sharing your website.

Leave a Reply

Your email address will not be published.


*